南京林业大学学报(自然科学版) ›› 1980, Vol. 4 ›› Issue (04): 84-98.doi: 10.3969/j.jssn.1000-2006.1980.04.010

• 研究论文 • 上一篇    下一篇

介质循环速度与干燥均匀性关系的探讨

金咸璋   

  • 出版日期:1980-12-18 发布日期:1980-08-18

RELATIONSHIP BETWEEN AIR CIRCULATION VELOCITY AND WOOD DRYING UNIFORMITYIN KILNS

Jin Xianzhang   

  • Online:1980-12-18 Published:1980-08-18

摘要: <正>测定了三座侧面通风型干燥窑内的气流循环速度,发现循环速度的分布极不均匀,但有规律。速度变化的一般模式如下:沿窑身高度的纵轴由上往下,风速由低而逐步增大,到最大值后逐步减小,在稍高于风机边缘上部的纵轴中点处风速最低,然后气流改为与以前相反的方向流动,重复上述模式的速度变化。一般认为,此种型式的干燥窑,由于风速的严重不匀,会影响材堆内各处的木材干燥的均匀性。但三座窑内分别进行的以常压过热蒸汽为介质的干燥试验的结果和方差分析表明,沿材堆高度、宽度与长度的差异不显著,即气流循环速度分布的不均匀对干燥的均匀性无实质性影响。设想的解释是:1、在以过热蒸汽为介质的干燥过程中循环速度大于测得的空气速度;2、从木材中蒸发出来的水蒸汽使循环速度有所加快;3、从较湿木材中出来的水蒸汽提高了较干木材的表面平衡含水率,因而降低了较干木材的干燥速度。

Abstract: Air circulation velocities were measured in three lumber drying kilns of the lateral fan type and were found to be nonuniform in different parts, but regular. The general pattern of the velocity is as follows: along the vertical axis from the top of the kiln to the bottom the circulation velocity is of a low value at the top, increases gradually downwards and then decreases to the minimum at the middle level of the vertical axis somewhere just above the rim of the fan. The air then flows back in the opposite direction and repeats the pattern described above.It is believed that the uneven air circulation would cause nonuniformity in the dryness of the lumber in the stacks, but on the contrary, analyses of the variance of the final MCs based on the results of superheated vapour drying experiments carried out in these three kilns at an average temperature of about 110℃ showed that the differences of the final MCs along the height, the width and the length of the stacks are statistically insignificant, which would mean that the unevenness of the circulation of air exercises little influence to the lumber at different positions of the stacks. Reasons for this phenomenon are assumed as follows: Firstly, the real circulation velocity of the superheated vapour might be much higher than the measured veloeity of the flowing air. Secondly, the great amount of vapour evaporated from the lumber might increase the circulation velocity during the process of superheated vapour drying. Thirdly, the vapour coming from the wetter lumber pieces might raise the EMC of the drier pieces so as to prevent the latter from drying faster.